How to install and debug the mold on 100t CNC hydraulic press brake?

  • 2020-07-29 10:07:06

How to install and debug the mold on 100 ton CNC hydraulic press brake?

The 100 ton CNC hydraulic bending machine mold is composed of many parts, so special attention should be paid to the installation and repeated debugging when it is completed. Generally, when we install and adjust the press brake mold, we will divide it into five parts to complete.
CNC hydraulic bending machine
1. The adjustment of the press brake. Before installation, the performance of the machine must be adjusted first. This process must be carried out patiently and carefully. Check whether the machine has dust and used iron chips, etc., and carry out necessary cleaning to reduce the later troubles.

2. To adjust the stroke of the slider, pay attention to check the thickness of the mold and check if the ratio of the upper and lower modules is normal. Normally, the module should be controlled at the switch point of the stroke line. This must be paid attention to.

3. The adjustment of the stroke module is to adjust the upper limit point of the module. When the module is up to the highest point, set the switch and reserve the position of the slider. At the same time, decelerate when going down to protect the hydraulic press brake and mold better

4. The adjustment of the gap is mainly to measure the distance between the upper module and the lower module. The specific gap setting is determined by the folded plate sheet.

5. Angle adjustment. The adjustment of this angle has a certain relationship with the product. Generally speaking, when we need to fold the mold into 90°, the middle angle must be greater than the angle of the two sides, so its tightness can be carried out according to the adjustment of the screw. At the time, the pressure can be adjusted through the pressure gauge to avoid die chipping.

The above is the method to correctly install and debug the mold of the 100 ton CNC hydraulic press brake.  Hope it will be helpful for everyone.

Product details: CNC hydraulic press brake

Copyright © 2015-2020 Anhui Aoxuan Heavy Industry Machine Co.,Ltd.All Rights Reserved.


leave a message

leave a message

    If you are interested in our products, please leave a message here, you will know more details.