other
Blog

Notes for using punching and shearing machine

  • 2019-08-22 18:08:15

Notes for using punching and shearing machine


(1) Punching and shearing steel plate, round steel, square steel, shape steel and so on can be carried out simultaneously.But two kinds of steel should not be cut at the same time.


(2) Cutting and quenching steel and processing beyond the capacity of the equipment are strictly prohibited.


(3) The cutting tool and cutting edge should be kept sharp. If the cutting edge becomes blunt or crack, it should be replaced in time.


(4) shear steel plate, round steel, square steel.Sections must be pressed down.


(5) When the equipment is running, it is strictly forbidden to touch the rotating surface of the machine parts with your hands, measure the workpiece, and clean the scraps directly with your hands.


(6) The operator must stop when leaving the machine, and check the original position of the handle in all parts before starting up.

Punching and shearing machine

(7) Don’t shear laminated plate, don’t trim the edge of raw edge plate, don’t shear pressure is not tight narrow plate and short material.


(8)When two or more people work together, one person must be unified in command and act in a consistent manner.


(9) When feeding, the fingers must be away from the edge 200mm, and special tools should be used for small pieces.


(10) The operator should concentrate on it. It is strictly forbidden to connect the car and not to feed from the opposite side of the joystick.


(11) Operate in strict accordance with operating procedures.

Copyright © 2015-2020 Anhui Aoxuan Heavy Industry Machine Co.,Ltd.All Rights Reserved.

top

leave a message

leave a message

    If you are interested in our products, please leave a message here, you will know more details.